※ For some cases, development cost or prepayment for special parts/material may be required.

1.  Greese

• Change to special grease or spread volume change : for durability, we need to test it based on request.
  ※ For special grease, we may require some prepayment to secure it.

2. Rod End Tip / Rod

• Special shape rod end tip.
• Rod material change.
• Drawing is required.

3. Rod-End Starting Point Adjustment

• The general specification for the starting point (when fully retracted) tolerance is +/-0.5mm.
• For the same model, there may be a slight difference in starting point depending on the assembly characteristics.
• For customers who want to precisely match the starting position of the rod-end for the customer’s special application, we can match the tolerance to +/- 0.1mm or less. (with some charge)

4. Firmware

• Add special feature or Control characteristic change including PID value change
  Ex) We are applying slightly different PID value for certain application according to customer request

5. Metal Parts (Center/Output gears, Rod-insert) 

• The standard engineering plastic center gear, output gear and rod insert have been developed through intensive test considering for durability, impact resistance and lubricity.
• Under special condition, however, we can apply metal parts for those plastic parts for better impact resistance.
• If we apply metal parts, lifecycle of actuator will be shortened due to gear wearing (1/5 of engineering plastic gear) and mechanical play can be made faster.
• Therefore, metal parts can be applied for the application whose operation frequency is not that high while they need stronger impact resistance.
• Metal center gear can be applied to all stroke lineup except for 27mm stroke version.

6. Top case

• The Top case(Yellow marked) can be changed as above according to customer’s request.
• Custom1-Plastic Flat : Same engineering plastic material with 4 x mounting holes.
• Custom2-Metal Flat : Metal alloy, Mounting hole can be customized to M3 or M4 (standard : M2.5) (Material cost to be increased).
• Change at customer’s side is not permitted. (Change at factory only)

7. Connector Outlet (Minimum Q’ty : 200pcs) 

• Original

  

• Custom 1 – Rubber Cap
  –  Applying rubber cap without connector for water/dust tight condition.
  

  

• Custom 2 – Remove Connector Outlet
  – Remove connector outlet for space constraint
  – Need to make a new PC board and prepayment(U$5,000) for the 500pcs PCB will be required.
  – Actuator can be shipped partially(more than 50pcs)
  – Prepaid amount will be deducted from the actuator cost)
  

  

8. Circuitry (Minimum Q’ty: 500pcs)

• PCB change
  – As mentioned before, prepayment(U$5,000) for the 500pcs PCB will be required. Actuator can be shipped partially(more than 50pcs) and prepaid amount will be deducted from the actuator cost
• Special motor
  – (Voltage/ Force/lifespan) : Due to MOQ of DC motor, prepayment is required for DC motor cost. Prepaid amount will be deducted from the actuator cost.